Dimensional Analysis — Question 1

Section 1-6 · Chemistry pages 107–108

Show solutionHide solution

Question 1

Follow a length through an unfamiliar unit

A protective film has a measured thickness of 2.75 mil. Here mil means one-thousandth of an inch, not millimeter. Round an exact halfway case upward. Use the exact definitions 1mil=0.001in1\ \mathrm{mil}=0.001\ \mathrm{in}, 1in=2.54cm1\ \mathrm{in}=2.54\ \mathrm{cm}, and 1cm=104μm1\ \mathrm{cm}=10^4\ \mu\mathrm m.

Diagram shown in the original SVG worksheet.

  1. Convert the thickness to micrometers using one chain whose intermediate units cancel.

  2. Express the result in millimeters using 1mm=1000μm1\ \mathrm{mm}=1000\ \mu\mathrm m exactly.

  3. Explain how a unit check exposes the invalid setup 2.75mil×(1mil/0.001in)2.75\ \mathrm{mil}\times(1\ \mathrm{mil}/0.001\ \mathrm{in}).

Question 1 - Solution

Follow a length through an unfamiliar unit

Diagram shown in the original SVG worksheet.

(a) Arrange conversion factors

d=2.75mil0.001in1mil2.54cm1in104μm1cm.d=2.75\ \mathrm{mil}\,\frac{0.001\ \mathrm{in}}{1\ \mathrm{mil}}\,\frac{2.54\ \mathrm{cm}}{1\ \mathrm{in}}\,\frac{10^4\ \mu\mathrm m}{1\ \mathrm{cm}}.d=69.85μm→69.9μm.d=69.85\ \mu\mathrm m\longrightarrow\boxed{69.9\ \mu\mathrm m}.Each unwanted unit cancels, leaving the requested unit. The measured input limits the report to three significant figures.

(b) Change to millimeters

Using the unrounded intermediate value,d=69.85μm1mm1000μm=0.06985mm→0.0699mm.d=69.85\ \mu\mathrm m\,\frac{1\ \mathrm{mm}}{1000\ \mu\mathrm m}=0.06985\ \mathrm{mm}\longrightarrow\boxed{0.0699\ \mathrm{mm}}.Exact conversions preserve the input significant-figure limit.

(c) Audit the inverted factor

The proposed setup leaves units mil2/in\mathrm{mil^2/in}, not inches. The first factor must have mil in its denominator. A conversion factor is numerically useful only when its orientation also gives the required unit cancellation.

Check and interpretation

One mil is 25.4 micrometers, so a few mil correspond to tens of micrometers, not several millimeters.