Dimensional Analysis — Question 4

Section 1-6 · Chemistry pages 113–114

Show solutionHide solution

Question 4

A surface loading needs a squared conversion factor

A coating specification requires a measured surface loading of 4.80 mg per cm2\mathrm{cm^2}. The surface area to be coated is 0.125 m2\mathrm{m^2}. Assume uniform loading and no waste. Use exactly 1m=100cm1\ \mathrm m=100\ \mathrm{cm} and 1g=1000mg1\ \mathrm g=1000\ \mathrm{mg}.

Diagram shown in the original SVG worksheet.

  1. Build a single chain to calculate the required coating mass in grams.

  2. Explain why the meter-to-centimeter factor must be squared.

  3. A student obtains 0.0600 g by using an area conversion factor of 100. Find the factor by which this underestimates the correct result.

Question 4 - Solution

A surface loading needs a squared conversion factor

Diagram shown in the original SVG worksheet.

(a) Convert area before canceling it

m=0.125m2(100cm1m)24.80mg1cm21g1000mg.m=0.125\ \mathrm{m^2}\left(\frac{100\ \mathrm{cm}}{1\ \mathrm m}\right)^2\frac{4.80\ \mathrm{mg}}{1\ \mathrm{cm^2}}\frac{1\ \mathrm g}{1000\ \mathrm{mg}}.m=6.00g.\boxed{m=6.00\ \mathrm g}.The chain leaves grams and retains three significant figures.

(b) Apply the factor to both dimensions

1m2=(100cm)2=104cm2.1\ \mathrm{m^2}=(100\ \mathrm{cm})^2=10^4\ \mathrm{cm^2}.An area contains two length dimensions. Using the factor 100 converts only one of them and leaves the numerical area too small.

(c) Compare the masses

6.00g0.0600g=100.\frac{6.00\ \mathrm g}{0.0600\ \mathrm g}=\boxed{100}.The wrong area factor is 100 instead of 10,000, so the estimated mass is one-hundredth of the required value.

Check and interpretation

The area is 1250 square centimeters. Multiplying by 4.80 mg per square centimeter gives 6000 mg, consistent with 6.00 g.