Catalysis — Question 9

Section 12-8 · Chemistry pages 2143–2144

Show solutionHide solution

Question 9

Test for transport effects before assigning intrinsic kinetics

With the same solid catalyst and bulk composition at controlled temperature, measured rates are 0.0100, 0.0180 and 0.0180 mol min−1^{-1} at stirring speeds 100, 300 and 600 rpm. Measurements are reproducible within 2 percent.

Diagram shown in the original SVG worksheet.

  1. Interpret the low-speed change and the high-speed plateau.

  2. Design an additional test and explain why the plateau alone does not rule out every transport limitation.

Question 9 - Solution

Test for transport effects before assigning intrinsic kinetics

Diagram shown in the original SVG worksheet.

(a) Reasoning and result

The strong increase from 100 to 300 rpm suggests that mixing or external mass transfer influenced the low-speed measurement. The unchanged rate from 300 to 600 rpm suggests further stirring no longer changes the controlling resistance over that range.

(b) Analysis

Vary particle size at matched accessible catalyst amount and compare normalized rates, while controlling temperature and composition, to probe internal diffusion. A stirring plateau can coexist with diffusion inside pores or another limitation unaffected by bulk stirring.

Check and interpretation

The plateau is evidence about stirring sensitivity, not a complete proof of intrinsic kinetic control.