Polymers — Question 7

Section 22-5 · Chemistry pages 3699–3700

Show solutionHide solution

Question 7

Infer crystalline mass fraction from a two-phase density model

A hypothetical polyethylene sample has density 0.920 g/cm3. Treat it as crystalline material of density 1.000 and amorphous material of density 0.850 g/cm3 with additive volumes and no voids or additives. If w is crystalline mass fraction, use 1/ρ=w/ρc+(1−w)/ρa1/\rho=w/\rho_c+(1-w)/\rho_a.

Diagram shown in the original SVG worksheet.

  1. Calculate w and explain why directly interpolating density would correspond to a different weighting assumption.

  2. Explain how additional branching can interfere with regular packing, and give one reason density alone is insufficient without the supplied two-phase assumptions.

Question 7 - Solution

Infer crystalline mass fraction from a two-phase density model

Diagram shown in the original SVG worksheet.

(a) Reasoning and result

w=(1/0.920−1/0.850)/(1/1.000−1/0.850)=0.50725w=(1/0.920-1/0.850)/(1/1.000-1/0.850)=0.50725, or 50.72 percent by mass. Mass-weighted specific volumes add here. Linear interpolation of the densities would instead correspond to volume fractions in a no-excess-volume model.

(b) Analysis

Branches can obstruct close, regular alignment of chains and reduce crystallinity under comparable conditions. Voids, additives, phase densities or thermal history can also alter bulk density. Without controlling these contributions, density is not a unique measure of branching or crystallinity.

Check and interpretation

The inferred mass fraction lies between zero and one and reproduces the given density through the specific-volume equation.